One of the most important aspects of a building is the water and sewerage system. An efficient system will allow the coming in of clean water and the safe disposal of waste.
There are many appliances which use water in buildings including toilets, sinks, showers, and water fountains. Since these are appliances that are used heavily in buildings, they are prone to breaking down or blocking from time to time. A plumber is therefore required to have the skills to install and repair such appliances including carrying out shower repairs.
One of the common causes for shower repairs is a shower faucet or valve that leaks. You can end up losing plenty of water from a leaking shower faucet. It gets worse if the leak is from the side that brings in hot water. This is because the water heater will warm more water than is required due to the leak resulting in a loss of energy. The water can also get into the wall causing it to rot and this will cost you since the repairs may end up being very expensive.
Why Shower Faucets Leak
When you have a shower head that is dripping, it is because the shower faucet has a problem. Sometimes the shower faucets can get blocked by deposits from water or parts of the shower faucet may be rusty. It may also be that the seals found within the shower faucet are worn out.
The gaskets or rubber rings that are found between the metal parts which move are prone to wearing down and when this happens, water begins to drip. When you have a dripping shower, make sure not to tighten the valve handle too much as this can damage it thus increasing your shower repair costs.
When conducting shower repairs, a plumber will normally lay rags on the floor of the shower or the bathtub before doing any work. This is important in order to avoid any parts of the faucet falling down the drain. A valve that shuts off the water supply to the shower is then turned off, and it is normally located in the bathroom or in the basement. The method used to make the shower repairs will depend on the type of faucet that is in use.
A compression valve or faucet is one which has two valve knobs, whereby one brings in cold water and the other one is for hot water supply. The washers and rubber seals present in compression valves normally wear out causing water to come through the movable parts. A compression valve can be repaired by disbanding the faucet and replacing the faulty washers and rubber seals. The plumber needs a faucet washer kit which has all the parts required for repair work.
Delta Shower Valve
If the shower repairs involve a Delta shower faucet that is leaking, the handle has to be removed to expose the cartridge. The plumber then removes the cartridge and cleans the faucet area with a rag to remove any deposits. A new cartridge is firmly put in place and the handle is placed back in its proper position. Other types of shower faucets including the Moen shower valve and the Pfister shower valve also require a replacement of the cartridge.